WORK DETAILS
WORK DETAILS
RATE 1800/- PER SQFT
(Rate very as per requirement)
- Excavation.
- Cleaning of the site, making hutments for labor.
- Columns and brick foundation.
- Columnsize to be 9" x 14" 4 bar on 16mm, 2 bar of 12 mm.
- Brickwork to be 2 ft 6 inches high.
- R.C.C roof slab.
- Plinth beam to be9"xl2" with 6,12 mm bars.
- R.C.C. work in M20/M-25 (walls, footings, columns, stairs, beams, slabs,underground storage tank etc.) APP membrane 3 mm thick to be pasted (with torch)over DPC which in turn will be placed over plinth beam.
- No RMC (Ready Mix Concrete) to be used.
- Admixture to be used in total R.C.C. work. Co-Dr. Fixit-LW1OO.
- Ply/Steel shuttering to be used in columns,fascias, beams, slabs etc with shuttering oil.
- Grade of steel -500n/mm2Co. Tehri Gold Steel.
- Only washed Paontabajri and crusher to be used in R.C.C.
- Cement grouting using LW-100 admixture from Dr. Fixit in 1:6.
- Mixer and vibrator to be used throughout the construction.
- Mud-filling inside the rooms (upto plinth level).No malba or organic material to be used in filling.
- Plinth level not to be = 3"-6" from the highest point of the adjoiningroad.
- Cement use: --(i) Ultratech(ii)ACC (iii)Ambuja.
- Anti -termite treatment to be done in three stages (Foundation/Flooring/Apron).
- Clear height of each floor should not be less than 11'-0".
- Damp Proof Coating (DPC) = 2" thick in 1:5 cement: sand ratio mixed with water proofing compound and with APP membrane 3mm(pasted with torch) underneath it.
- Toilets floor to be sunk to make provision for sanitary pipes.
- All external walls to be 230mm(9 inches) thick.
- 230 mm thick b/work with 1stclass bricks (as stated, the 1st class bricks in ratio- l:6.
- 115 mm thick b/work with 1stclass brick course in 1:4 cement, sand ratio.
- Fixing of D/W frames along with b/work with a minimum of three anchors/hold fast.
- Corbels/offset in b/work to be done if required.
- Niches to be provided as per the drawings.
- All walls, beams, roofs & b/work to be plastered, withl:6 cement:sand.
- Wire mesh to be fixed at the junction of brick and R.C.C.
- Plain plaster internal and external in ceiling,beams and edges1:4(1 cement: 4 fine sand) and walls 1:5(1 cement:5 fine sand). Water proof compound to be mixed in plaster at critical areas.
- Rough Plaster to done for fixing tile.
- External plaster will have designs in the front as per the drawings
- RCC slabs to be casted wherever required (In- store, almirah etc).
- Two coats of pidifin 2k (dr fixit) to be applied on all the internal and external wall surfaces till 4 ft. before plastering.
- RCC lintel beams to be provided in all the openings (as per the drawing) with sunshades 2'- 6" wide 3" thick at 7'-0" in ground & first floor(Wherever required as per the drawings).
- RCC slabto be min 5" thick or as/specified in the drawings with steel plate shuttering.
- RCC mix to be M20/M25 as specified. Steel as per the drawing.
- Mixer & vibrator to be used.
- Khaskagola/corbelling under roof and sun shades in front elevation, work as per the drawings
- Ply/steel plate shuttering to be used.
- RCC slabs to be provided in store and wherever required.
- RCC slabs in utility for washing machine below counter and storage space shelves above with covers.
- RCC shelves in store room.
- All the sunken portions of the toilets to be filled with brick ballast &and to be made water tight with two coats of pidifin 2k finished with PCC (Plain Cement Concrete). Weep hole to be provided in all the wash rooms.
- Finishing - All room floors to have vitrified tiles/pre-laminated wooden flooring or as specified in the drawings cost not less than Rs. 70/-sqft. Co. KAJARIA ETERNITY, NITCO, or equivalent.
- All toilets will have anti- skid tiles in the floor and walls will have glazed vitrified tiles till 7ft(door level) rate to be not more than Rs. 50/-Sqft.
- Anti- termite treatment to be used in junction of walls and floor with 7.5 liter per meter to be poured along the periphery.
- Base of flooring should have (a) Brick ballast = 3" thick (b) Sand filling = 3" thick (c) PCC = 3" thick in ratio of 1:4:8 & plate vibrator to be used while laying PCC.
- All window cills and stair treads to have granite ledge with half moulding on both sides. (Cost not less than Rs. 70/- sqft).
- Kitchen to have glazed vitrified tiles 2 ft above the counter and normal white tiles behind the cabinet.
- Stairs to have granite treads (cost not less than Rs. 70/- sqft) & risers to have vitrified tiles as per selection (cost not less than Rs. 70/- sqft).
- 2'6" wide Apron to be made all along the building(after doing anti-termite treatment all around).
- Steps /ramp leading to G. Floor wherever shown in the drawings.
- Over head water tanks to be providedfood grade – white/black color)@500 Liter Company- Sintex over a pre-fabricated m.s platform.
- Manholes to be connected with PVC pipes & discharged to the last man hole.
- CPVC pipes to be used.
- Company - Astral.
- S.W.P, W.W.P and R.W.P. will be from Co. Supreme pipes.
- Diverters (in basin and shower) to be provided in all the washrooms.
- Geyser provision.
- Provision for Laundry,dishwasher etc.
- All rainwater pipes to be connected with an underground drain,manholes & the same to be diverted into a rainwater harvesting tank (before passing through the de -silting chamber) of apprx. 5000 litercapacity. The surplus water should get diverted to the recharge pit.
- Seat- Wall hung W.C. with seat cover, jet spray and health faucet.
- In wall tank - Diverters (Hot &Cold water Mixers) for WC(s).
- Wash Basin - Under the counter basins.
- Wash Basin Counter- to be of granite stone cost = 170 per sqft.
- Vanities- in basin area to be provided.
- Diverter in bathing area.
- Wall Diverter in wash basin.
- Over head shower.
- Provision for Geysers to be given
- Bathing area to have ledge 2" high of granite. On the floor: Anti - Skid Tiles
- Modular kitchen under 1,00,000/-.
- All civil work and the counter to have granite top cost not less than Rs. 170/-sqft.
- Glazed vitrified tiles till 2 ft above the counter and normal white color tiles behind the cabinets. 40/-
- Sink - Nirali S.S sink one double bowl single drain board. (3500/-)
- Faucets - from co. Kohler
- Mixer -one freshwater outlet and one hot and cool mixer from Kohler co. (2200/-)
- Provision for geyser
- Flooring will have anti-skid vitrified tiles.
- Provision for geyser, chimneys and exhaust fans will be there.
- All electrical points as per the drawings issued by the modular kitchen agency.
- To be made in 35/30 mm thick per designs) flush door with teak ply 4 mm thk.
- Door shutters to be wood finish.
- Aluminum/ UPVC Co. Schueco / Tostem /Fenesta.
- Plastered surfaces - Two coats of Apex Ultima over one coat of Snowcem & Primer.
- OIL BOND paint from Co. Asian over two coats of Birla putty in living area& lobby.
- Oil bound distemperover 2 coats of Birla putty base in other areas.
- All metal work should have two coats of enamel paint over primer.
- **A11 Paints mentioned above to be of Company Asian Paints. **
- Modular Switches of POLYCAB.
- Electrical work with copper multistrand wires in concealed PVC conduits (co. POLYCAB).Provision shall be made for sufficient lighting, power points, Switches & sockets.
- Chemical copper Earthing to be done as per the requirement.
- T.V. points in each bedroom/ Drawing/ Dining room.
- Wires of FRLS (Fire Retardant Low Smoke) grade- Company: polycab.
- Double door distribution board M.C.B (Company - HAVELLS)
- Exhaust fan provision to be given in every toilet and kitchen.
- Invertor wiring provision to be given.
- Provision for outdoor security lights to be given.
- Provision for Split AC(s)(all weather hot and cold) with proper location of outdoor & indoor units including electrical supply.
- Provision for Wi-Fi/Lan.
- Provision for Geysers -All wash Rooms and the Kitchen + utility.
- Provision of R.O. in kitchen.
- 1. Advance - 5%
- 2. After Columns Digging -10%
- 3. For Steel Work (Columns)- 10%
- 4. Plinth Beam Level - 10%
- 5. For Brick Work -5%
- 6. Door Chaukhat And Windows Work (Approx)-5%
- 7. Column Work & Brick Work CompleteUpto Roof Level- 5%
- 8. After Roof Casting -15%
- 9. For Electric and Sanitary Pipes - 5%
- 10. Out Side Plater - 2%
- 11. Inside Plaster - 5%
- 12. For Wall Putty Work - 3%
- 13. For Floor/Wall-Tiles/ Stone Work - 10%
- 14. For Electric Wires - 2%
- 15. For Sanity Wares - 5%
- 16. After Completing - 3%
- 10 YEARS ROOF SEEPAGE GUARANTEE
Social Media
© www.doonshivaconstruction.com, All Right Reserved.